Well, I've made the decision to sell my car. :cryying: Going through a divorce so it has to go.
About 4 months ago a deer ran into me (never say you hit a deer) and have a new Hood and left front Fender. It didn't impact that hard. Nothing structural has been compromised. It was in the body...
Has anyone used the NGK Powerdex AFX Air Fuel Monitor sold by Summit Racing?
http://store.summitracing.com/partdetail.asp?autofilter=1&part=NGK%2D91101&N=400395+319368+115&autoview=sku
Its only $265..cheapest A/F wideband monitor I've seen. I think you have to remove the sensor after...
Just installed BBK Twin 65mm Throttle Body and have sticking off idle. Instructions say if there is binding at throttle tip-in to adjust the idle screw. When you adjust to go past sticking, it idles too high. When I had TB on bench, it seemed to rotate freely without any binding. After install...
Has anyone tried the Trans-Adapt Torque-Curve MPFI Spacers available at Summit P/N TRD-2569 $46.39 ? http://store.summitracing.com/partdetail.asp?autofilter=1&part=TRD%2D2569&view=4095&N=4294908331+4294908282+4294907915+4294924641+4294925239+0
Has anyone put M&H Racemaster 390/40R17 tires on their car? Where do you get the wheels for these? :shrug: Here's a link to a west coast store. http://www.mandhtires.com/store.php?crn=70&rn=295&action=show_detail
I'm replacing rear springs on my vert with coupe springs. What about replacing front springs? According to info I have front vert front spring is 500lb. and coupe is 600lb. Has anyone replaced the front springs on their vert along with the rears?
Thanks
What is the short answer to wheel hop on these 03's? Just upgraded to around 475HP and can't get through first gear without the hop. We use to install 'Traction Masters' on the bottom plate of the axle springs. What do you do with this independent suspension? :whine: :rolleyes: :??: :)