Got my first ever Dyno pull this morning on my 03. My only mods
are Magnaflow catback and Steeda CAI. The dyno was a Super Flow using a tail pipe probe. Three pulls were made, each with the same results. The A/F looks good until around 5200 rpms and it suddenly goes lean thru the roof. No...
Ok, got my Steeda CAI today. I have a couple of questions. I searched already here and at Steeda's faq with no luck. The installation instructions make no mention of how to clean the filter or weather or not it requires oiling to use. No oil came with it so I assume it does not require it, but I...
I would like to know of some good dyno shops in Ga where I could get my Cobra tested. I've never been to one so any tips you guys could give would be great. I live 2 hours from Atlanta which is most likely where I will have to go. Thanks.
Not sure if this is a dumb question or not.... I'm assuming that if
upper pulleys are smaller that a lower would be bigger in diameter. If so, does that increase the rpms to the accessories like the AC, alternator etc?
Alright, this may be a dumb question... but.. How do you increase boost on a turbo charger? Supercharging I get, you change the size of the pulley. I assume there is no pulley to change on a turbo charger if it is an impeller driven by exhaust gasses. I'm clueless here....
Ok, how many of you have gone off the deep end like me? I have a nice shiney magnaflow exhaust system. The outside is all bright and nice. The inside of the tips started looking all crummy with some white looking residue/corrosion. I found my self sticking the polishing rag inside the pipe and...
When Ford rates our engines at 390 horsepower, what type of intake/air filter and exhaust system are they using, if any? I understand it is at the crank with accessories hooked up. Is that right?
Just got thru reading the latest MT. The next gen vette will be coming out in 05. They say it will be lighter and be 425 hp with a z06 version pushing 500 hp.
Ok, not sure if this is a dumb question or not. I'm assuming that a smaller blower pulley causes the blower to spin faster thus creating more boost. Would the extra rpms on the blower cause it to wear out prematurely? What would the life of a blower be vs one with a pulley? Or would we even...