I recently installed a mach 1 motor with 98 cobra cams. I dynoed the car at 300/310 my cobra has CAI,3:73, catted X and catback. I ran it at the track and netted a 13.1@103 1.78 60ft. My question is could my 98 cobra cams be installed incorrectly?
I installed MM plates on with H&R springs Im using the Bilsteins but since the install over bumps I have a clunk coming from that area I installed the spacers like the picture recommended any suggestions?
Ok so long story short I found a donor Aviator motor and its being installed. What are some issues im looking to come across? So far I know this
Change whole timing cover
intake etc
03-04 manifolds
oil pan
6 bolt flyhweel
anything else ive might of missed?
So I came across a 99 Cobra with a tick I thought it was a lifter issue, but I have replace all the passenger side (16) the tick is still there. If I disconnect the injector the noise goes away someone suggested that it might be the wrist pin that is causing the noise that you can hear from 800...