lowranger96's latest activity

the ATS S197 13.25" rotor spacers are 3/16"

That's a good idea, I'll try to work on this and host it on the website. ssengineeringllc does have an online store now, finally. I...

Sending him a PM would probably be better. He also runs a Facebook page where you can contact him.

Check your bias without the proportioning valve here: SN-95 Mustang Brake Bias Calculator For a 94-04 Mustang, you want your front bias...

We now have brackets in stock for IRS and SRA.

Great news! S&S Engineering LLC (company that makes ATS & XTS front adapters) is now machining and selling these rear rotor adapters for...

The '00 R brembos have the same clearance issues as the ATS stuff. Putting 2 pistons on the outside of the caliper requires space...

That logic is tough to apply since cobra calipers are externally the same size with two different piston sizes between the rears and...

IIRC it’s slightly smaller but wasn’t enough of a difference for the wheels I was testing.

I’ve had both in my hands and test fit a wheel that wasn’t fitting on the cobra R setup with an ATS. They are both about the same...

Keep in mind the hoses are very dependent on the year of car (fox, sn, new edge). I’m not sure what you have but sn/new edge would be a...

This sounds like air in the front calipers. Did you bleed them in the following order? RR LR RF inner RF outer LF inner LF outer

3/16 spacer required (I sell laser cut versions for $35/pair shipped) the pad fits great on the OD of the rotor, they hang off on the...