I'm swapping a powerglide into my car so I am selling my th400 setup.
What I have is what the old-school Top Fuelers used. Its a TH400 that uses a Clutch instead of a converter. Otherwise known as the "Poor Mans Lenco". You only use the clutch for start/stop.
The "Pump Drive" is all BRAND...
Ok, so as per my other post. I am working on a 2008 GT that has a manual VB 4r70w swapped into it.
The PCM code written on the PCM is: KHK2 (which is an Auto PCM)
The code I am trying to flash onto it is: XZE2 (which is a Manual PCM code)
Anyway, I have a no start condition with it now...
I had this 2008 GT mustang come to me from another shop. It's has a manual valvebody 4r70w swapped into it, along w/ a few bolt-ons. PCM code: KHK2
Anyway, the biggest problem i am having is when I turn "Trans Auto Switch" & "Trans Load Switch" to "0", the Wrench Light comes on instantly...
Turbo 5.4 Mustang vs Turbo 408 TA (FR8TRN)
Went for a cruise with a couple buddies and had some 60-160 rolls. My mustang is a built 5.4 DOHC w/ 88mm turbo. The silver TA is the turbo 408 TA you have seen in the 1320videos mostly at TX2K. Both cars are on 15psi in the vid. My mustang is running...
Ok, obscure build here...
04 Ford Explorer AWD 4.6 SOHC w/ 5r55w trans & factory 3.73 gears
Mods:
-Elec Fan
-Elec Water Pump
-CAI
-UDP
-No Cats w/ factory exhaust
-X-cal 2 w/ Custom tune
The passenger side chain burned through the guide and was rubbing on the tensioner. So during the process...
I have 160lb low imp injectors I'm trying to run in my 97 Mustang 5.4 turbo car. I have the versafueler to run them.
My question is, how are others scaling these injectors?
This is where I'm at....
Found out my "no start issue" was from the fact that the power wire I had running the...
Selling for a friend, please do not reply to this add!!!
New P1SC Blower, (Completely rebuilt from procharger with 0 Miles)
New Procharger Bracket Kit
Used Piping and intercooler
used proflow Blow off valve
new 39.5 lb Injectors
used fucus fuel pump
used EGR Block Off
used Boost Gauge...