I recently install Steeda catbacks and 3 or 4 times since when I get on it hard then shift to 2nd it falls on it nose almost like when the traction control kicks in(I have TC off). All I have on the car is catbacks and cold air. Other than those few times the car has ran fine. Should I be...
After I have driven the car for a little while and it gets warm, I stop and let out on the clutch and have whine type noise as I let the clutch out. It only does this when the car is warm and I let the clutch out. Does this sound like the clutch? Do I simply need to lubricate something?
I'm removing the factory exhaust to install Steeda cat-backs. I was wondering what is the easiest way to remove the hangers from the rubber mounts? The front to look a little difficult.
Vibration and Noise (oasis report)
The cobra has been in the shop all week. It had a serious vibration in the rear that started small and has progressively gotten worse. It also came along with a roar that has gotten worse as well. I took it to the dealership and took the SVT tech(who owns a...
Taking the cobra to the dealer tomorrow for three things and wondering if anyone has seen these before. First the low idle or stall problem that I know alot of people have had. Second the the lumbar pillow in the driver seat has blown out the back of the seat, blow it up and get a big bubble...
I have taken my car to the dealership twice now and they say they cant find the cause of a popping noise on right hand turns. It is a very load pop and only happend on hard rights at speed. I decided to get under it and look at it myself and found the emergency brake cable was loose from a...
I recently took my car in for a pop in the rear. The dealership did the TSB for it and said they didnt find anything. I drove it for the first time saturday(for a period of time) and it is poping alot worse than before now. Actually a differnt pop. While at speed going through a right hand...
I was thinking of putting a set of 9007 Eurodezigns in the headlights and 9005 on the foglights. Was wondering if anyone had tried these or if they had any problems. I know with some of the brands they can cause some damage from heat and was looking for some input on the bulbs.