Recent content by Rickety

Bump........

SOLD!!!

I have a Brand new setup that I didn't end up using....If you are still looking.... Steve

Like this one???

Sold..........

These are almost brand new....Installed in new engines and oil primed....Never Ran... I have a few of these... $150 shipped USPS

Some used hardware for a pair of GT/GT500 Cylinder Heads.... 16- Orange Exhaust Springs 16- Light Blue Intake Springs 16- Intake Lash Adjusters 16- Exhaust Lash Adjusters 31- (yes 31) Roller Finger Followers... $300.....

Selling the Following Ford OEM parts... All Items are Brand New for 2015 5.0 Engine...... Left/Right Intake Cams.... 2 Intake VCT Phasers.... 2 Primary Chains... Crank Sprocket.... 6 Phaser Bolts.... 2 Phaser Filters..... I Purchased these thinking I could use em in a 2012 Set up.... I have...

Used TVS/Manifold/Cooler and supporting mods from a 2013......I was going to use this setup on my 5.4 Mod Fox swap, but have since went to a Coyote setup......I would like to sell it as a complete assembly....... Also included is an USED FRPP 113 mm cold air kit...... $2500/OBO +...

Brand New Never Installed with EITHER a used FRPP Dual 63.5 mm Throttle Body OR a Brand New Whipple Mono Blade Throttle Body...... I was going to use this in a 5.4 Fox swap, but it wouldn't fit under a 2.5 inch cowl.....I have since went to a Coyote Swap setup...... $3250/OBO + shipping...

Brand New 14042R-8 4.6/5.0 Manley Rods......ARP 2000 Bolts...Std Stroke.... I'll include Brand New Sealed Power CH-Series Rod Bearings 8-7250CH026X... $525 Shipped....These list for over $700 from Summit.... http://s244.photobucket.com/user/SagoSaso/library/For%20Sale?sort=3&page=1

99% New Parts..... Billy Briggs balanced and Piston fit the block..... Eyeball Link for pics and short list of parts..... Pretty much, what U see is what U get... PM with questions...... $19K get it.... http://s244.photobucket.com/user/SagoSaso/library/Cobra%20Jet%20Engine2?sort=3&page=1...

99% New Parts..... Billy Briggs balanced and Piston fit the block..... Eyeball Link for pics and short list of parts..... I modified the inlet to run an IAC, I was going to use it in my fox body and run it with a SYM2 EEC 4.....a plate/cover is covering up the two holes... I only have one...

Brand New NOS Set......I have no use for em.... $200 shipped(USPS)

.