Recent content by teamrev

I thought about the hockey puck route but read a lot of forms about how they can break. I just figured, "I spent how much on the car?? What do I really want to jack it up with?" By the way same response I just had when I went and looked at the Harbor Freight 1.5T aluminum jack on black Friday...

Here is what they look like on the car.

You are all correct. I cut the one down for the front because of the opening in the plastic, and I put the butcher block plastic in to tighten the gap on the pinch weld so the pad doesn't rock on the pinch weld. In the photo the one on the top left is cut down for the front jacking point and has...

On the Pinch Weld

Those were the ones I was going to buy till I found these at half the price. Couldn't see where there would be that much difference.

Click on the word "these" in the post. Or go here: https://www.fgtmotorsport.com/products/pinch-weld-magnetic-jack-pad-by-rocky-springs-automotive

Anyone heard of these guys? I was in need of some jacking pads and after searching many sites and many forms was always taken back by the price of these little guys. Found these at FGT Motorsports. 4 pads for $80 bucks..(they had 20% off and free shipping). They seem OK. I had to cut the front...