Recent content by white88lx

Thanks for the heads up. I'll do that when I get home

last of the photos

Selling my 2017 AMG C43, car has 6,300 miles and located in Connecticut. If you have any questions please let me know. Thanks Asking $49,000 obo

I disassembled the 8.8 for a rebuild, however I forgot to mark which sides the bearing caps came off of. Some help would be greatly appreciated. Thanks for any feedback

Just to let you know you don't need to put it on the rollers for Florida weather. The car was originally tuned in Florida (Jacksonville) with all the bolt ons. Just fyi I know this cause I am the owner prior to Todd that put all the stuff on.

I have a 2008 Shelby GT500 and the car has 20,000 miles. This car has been my pride and joy for the last 5 years and sadly it doesn't see the road as much as is needs too, I am settling down and trying to start a family and can use the extra room. The car makes 800 rwhp and drives just as good...

So I have installed an intercooler tank in the trunk and because of this I need to re route the liquid cool lines to the coolant system vice the intercooler lines. Problem is the inline adapters that was supplied from kenne bell is for a 3/4" hose and for my 2008 there is no coolant hoses that...

Here are a few pictures of the set up. Trunk mounted intercooler tank via Revan Racing. Hoses are 3/4" ID hoses and the flow path is, tank-->intercooler-->HX-->tank. I removed the pump on top of the heat exchanger just cause it seemed a little unnecessary and every pound loss adds up eventually.

There are not too may pictures of Mustangs with 18" Welds Wheels, If anybody has pictures or comments on how they look, opinions that would be awesome. Also, second topic: Is it common to have a staggered offset of 20's in front and say 19's in the back? or 19's and 18's? for a little...

So with an accident in the garage accidently scratched through one of the stripes on the hood. The scratch is about 2 inches long but the question is, if I wanted the stripe replaced is the best place the Ford dealer or are there aftermarkets that are better?

Set up: Full Length Headers 3" exhaust Spec Clutch Full Suspension and oh yeah....2.8KB with 3" pulley The pass was made on Stock wheels with Nitto's on all 4 corners and only made 3 passes. First pass was a dry run to get refamiliar, second run missed second gear. Confident I can drop...

Okay, car has about 200 miles on it from the installation of 2.8 KB, 3", KB dual boost a pump, headers, and exhaust. I was driving the car today and was making the turn to get onto the freeway not being driven hard and the car had no throttle response and the gauge said FAILSAFE MODE, I...

M122 supercharger w/2.6 & stock, JLT CF 110mm intake, stock TB Got stock M122 Supercharger with 2.6" pulley, stock pulley and Elbow. Supercharger has 15K miles. Asking $450 JLT Carbon Fiber 110mm intake. Asking $200 OBO Stock TB. Asking $75 I am located in Florida, if you have any...

At the dyno shop now. Any guesses, mods are as follows 2.8 kenne bell, 3 inch Pulley monoblade throttle body big 5 intake American racing headers full 3 inch exhaust

From what I have read and also talked with people it seems that I can extend the harness and get the stock o2 sensors to reach the longtubes without extensions. I have wasted many many hours trying to do this, I have disconnected the plastic clips that connect the harness to the bellhousing...