I recently completed an eaton swap on my 99 cobra it is all stock except a 2.9 pulley. I am still running the iac vavle is the stock on off the 99. The 03 one is on order and will be here tomorrow. Now for the issues the idle is high around 2000 sometimes seems to be more on first start up.when...
My lower supercharger pulley seems to be wobbling a lot and I am hearing a noise coming from that area that sounds like a bad bearing. I have the stock pulley and cage can I replace just the bearing or do I have to replace the whole unit. If so what's the part number for just the bearing or who...
So I think the bearing in my lower supercharger pulley is bad. It sounds like it is and that pulley seems to be wobbling around a lot is there a way for me to check it before I go buy a another one.
Well after months of work I got my eaton swap completed. Took the car up to Greg at RET on Friday for the tune and it put down 424 horse and 465 torque. Would like to thank everyone that helped by answering the many questions I posted.
I am finishing up my eaton swap and put a brand new auto meter phantom 2 boost gauge in my car today. I am running the 03 vacuum harness and have the gauge plugged into the right line according to the diagram I found on line that leads to the lower post on the back of the s/c. But my gauge isn't...
So I am about to finish my eaton swap but have a few questions
I cut the two outside wires on the maf and wire those to the Iat right? And it does it matter what one goes where?
When I take the wires from the Iat and wire them to the Iat2 sensor with the one with the red strip closest to...
I am doing a eaton swap on my 99 cobra and have swapped in a svt focus fuel pump. My question is is that pump going to be able to keep up or am I going to need a BAP? And if I need a BAP what one should I use the 20 or 40 amp?
I was putting my oil cooler on today that I bought used and noticed there is s threaded hole at the bottomed under the sensor. I think that a plug goes there but I'm not sure. If it is a plug what size is it?
I am doing an eaton swap on my 99 cobra and still running the 99 power steering pump pulley. It seems to be rubbing against the idler pulley but when I looked up the parts on autozones web site it says the 03 pulley is bigger. Not sure what I am doing wrong here do i need to change the pulley is...
I'm doing an eaton swap on my 99 cobra and wondering do i need to change the pulley on Tue power steering pump? It is rubbing against the idler. :shrug:
I have a 99 cobra that I am in the middle of doing an eaton swap on. I already have the kenny brown strut tower brace and I am wondering what intake tube I can use with this brace
I am looking for a detailed how to on doing the eating swap more then just a parts list. I have not been able to find any other then one done on a mach 1
I have a 99 cobra that feels like the rear end us walking around a lot when driving down the road. It gets kinda scary going down the freeway. I checked the tire pressure and the wheel bearings. All the bushings were replaced about a year ago and they all look like they are in perfect shape. The...
I have a 99 cobra that I want to do an eaton swap on and looking to trade the top end off mine plus some cash for the complete set up to do the swap. Also willing to buy just looking for a complete swap or a majority of the parts.