As the title says I'm looking for some Goodyear Eagle F1 Supercar tires for the 13-14 SVTPP wheels. They are of course 265-40ZR19 in front and 285-35ZR20 in back.
I'm in Los Angeles and would prefer to do a local deal but willing to drive a bit and/or pay for shipping if its a good price.
I...
I have a Fore triple pump setup but I need to pass CA smog and my CEL is on for missing the second fuel pump driver module (sold it like an idiot).
Anyways, if you have one lying around let me know, I don't even think it needs to work it just needs to be recognized as being there by the PCM (my...
Hey guys, I recently picked up most of a wrecked 02 lightning.
I am keeping the good bits, like the hood, fenders, bumper, grille, etc on the front end as I got in a front end collision on my car.
I don't have the full truck as some of it was sold previously, but I do have a bunch of parts...
Hey everyone, looking for a radiator fan.
It appears my high speed side failed, causing the fuse block pin to melt and the car to overheat...just my luck.
Let me know if you have any lying around for cheap, or if someone is looking to sell the new "performance" svt one that came in the 13-up.
Got a C&L 100mm CAI for the 07-12 GT500.
It barely has any use, as I got it used at 4k miles and never used it myself. Went with a different intake.
Comes with the silicone coupler even though it is not pictured.
$70 shipped. Located in Los Angeles and will accept Paypal/cash.
Like the title says I am looking for a set of complete front struts with springs and mounts. I don't care what they are, as long as they work, so since I am looking to spend less than $100 I was hoping I could get someones old stock setup if they have it lying around.
I just had my strut mounts...
Like the title says I'm looking for a single cop for the early heads on the 05-07 4.6l 3v
Lost one of them in the rebuild and looking for a single without the ford gouging.
Thanks
Hey everyone I have a gt500 k member and EPAS electronic power steering rack from a 2011 gt500.
I got these with an engine/trans I picked up but have no use for it.
Would prefer local pickup in LA but I will ship at buyers expense.
Only 2k miles on it.
Asking $250 for the whole k member and...
Hey I have a BA5000 from SCT that I was going to use on my last engine but ended up being fine with the stock MAF.
It has maybe 500 miles on it from the previous owner but I used it for dyno time only then swapped to a stocker.
FYI, the sticker fell off that says SCT on it but I GUARANTEE it...
Hey I have a BA5000 from SCT that I was going to use on my last engine but ended up being fine with the stock MAF.
It has maybe 500 miles on it from the previous owner but I used it for dyno time only then swapped to a stocker.
FYI, the sticker fell off that says SCT on it but I GUARANTEE it...
COMPLETE KB 2.6 Custom Blower + MORE! 650RWHP!
Hey everyone, selling my KB 2.6 out of my 2008 GT.
I hit 630rwhp when I had a failure in cylinder #7 (see pics).
I have Fore billet fuel rails that had to be modified slightly in the back, read--grinding lol, to fit with the boost bypass valve...
Hey let me know if you have either a PCM, engine harness, or power steering pump out of an 07-09 gt500.
I need one to make my 2011 engine work in the 08.
Thanks
Hey everyone...got some goodies for sale.
I bought a 2011 GT500 motor/trans complete with all accessories, steering rack/K member, Fuel Pump, and computer with only 2200mi.
I was planning on putting this in my 2008 GT, however the electronics are so different, that it would require me...
I've had these on the car for about 2 years, which means they have 10k miles or less.
They are a little dirty but they are in excellent condition.
I have Hawk HPS pads in the front calipers with tons of life left in them.
The rear kit is a set of 14" 2 piece rotors and caliper relocation...
I've had these on the car for about 2 years, which means they have 10k miles or less.
They are a little dirty but they are in excellent condition.
I have Hawk HPS pads in the front calipers with tons of life left in them.
The rear kit is a set of 14" 2 piece rotors and caliper relocation...
Selling an engine harness and PCM out of a 2011 I picked up.
Harness had a few cuts that I have repaired so it is like new with low miles.
The PCM is in perfect shape.
Asking $350 shipped.
Located in Los Angeles, PayPal or local cash sale.
I'll get better pics in a bit.
Hey everyone, got two of these a while back but ended up not using the second.
It is brand new in the box never been used or touched. Just took it out to take photos of it.
Comes with the drain valve and a Moroso sticker, please note Moroso does not include any fittings (besides the drain...
Hey everyone, got two of these a while back but ended up not using the second.
It is brand new in the box never been used or touched. Just took it out to take photos of it.
Comes with the drain valve and a Moroso sticker, please note Moroso does not include any fittings (besides the drain...
Hey everyone, bought a BA-5000 from minivanracer back in June.
He said it had 500 miles on it.
I used it for about 15-20 miles and Greg said my MAF counts are in the 900s so I can just use a stock one due to the 130mm oval housing.
The sticker fell off when minivanracer had it but he assured...
Hey everyone, bought a BA-5000 from minivanracer back in June.
He said it had 500 miles on it.
I used it for about 15-20 miles and Greg said my MAF counts are in the 900s so I can just use a stock one due to the 130mm oval housing.
The sticker fell off when minivanracer had it but he assured...
WTB: Stock front end parts/grills/radiator/heat exchanger/ac condenser/hood etc
Hey everyone...
So I f'd up my dad's truck which is a 2000 Lightning.
It's not too bad but I messed up all the front end parts.
I am in need of any stock front end parts anyone has.
I'll be needing a...