Search results

Somebody should loan you bigger zoom lens

These photos makes me want see so much more, they can't be more teasing.

I made air guides from aluminium sheet so that all air goes through cores. Have not tested it. I have car radiator as heat exchanger so it is as big there fits.

https://www.svtperformance.com/threads/marauder-bracket-eaton-swaps.1132518/#post-16276123

this don't make same effect in me, than previous pictures

https://www.autodoc.co.uk/facet/2178194 I use this, oem number can be found on that page. OEN 6G43-08-10064 — ASTON MARTIN OEN EG33-08-10726 — ASTON MARTIN OEN EPS 1.994.004 — FACET OEN KW 494 004 — FACET OEN 1 090 457 — FORD OEN 1 682 035 — FORD OEN 3 906 827 — FORD OEN 4 046 339 — FORD OEN 7...

I'd like to get Uni-T brand small scope. It would double as multimeter

He is famous actor and singer in my country :)

Could I use GT500 rotors, so I could use whole brakepad. I can machine outer diameter if it is too big, but is offset similar.

If I looked like that, I would have serious masturbation problem :)

I'm a fan, show us more!

I ordered Ender 5 Pro, still waiting for arrival. There are some desings in Thingiverse for Mustangs or other car related. I plan to make some interior parts, like gauge cluster to replace sn-95 clock.

Does Terminator ECM use boost signal for something, because there are no hints in software? Mach ecm has inputs I can use for logging. Ecm can't do anything with that data, but it makes analyzing easier. I think I have to check values by handpump to calculate voltage/boost ratio because there is...

I have swapped Terminator engine in my 1994 Cobra, project is nearly finished. I have 2003 original repair manual and Alldata access but I can't find where Boost sensor wires are connected, or what kind of signal they are giving. I have Mach1 ecm, and I'm using IAT2 instead of IAT in maf sensor...

My car is 1994 Cobra, engine from mach1 and I'm adding eaton m112 with partly selfmade swap parts (like Trilogy Motorsport set for Marauder) I'd need titles part shipped to Finland Europe, paypal in advance. I need at least the big hoses that connect to crossover. Picture from my engine

I'm making my own brackets. I used picture search a lot, and made test brackets from plywood. I made Inventor drawing from test bracket, and had them laser cut from mild steel. Sc bracket is ready, alt bracket needs some turned parts.

All vendors had regular prices, or even higher. And I always make my own exhaust after headers, current car being 1994 with 32v and irs rear.

I was trying to buy, "not available online" Apparently that was that :(

test continuity on either battery connector. + to start, - to ground

I don't know if this helps, but I swapped IRS in my 1994 Cobra, and used IRS axles sensors with 1994 ABS-module, so sensors and tone rings are similar. Sensors are not mechanically similar.