Search results

I have been looking all over the charts but not able to find the size for a 2.3 whipple with a 3.5 upper, stock lower, 3" alternator pulley and the metco 4 piece idler set (90 mm and 3 100MM)

Anyone have a post i haven't been able to find that shows where the bolts and studs go for the timing cover by chance? Been looking for a thread with a pic

Was able to get killer deal on a new 2.3 whipple but is made for a stock throttle body, are there any others or ways to change away from it? Worse case will run with it, but if other options....

Following a couple threads i was able to find searching with changing the power steering lines all to AN fittings and the diagram, but anyone able to confirm 908-5550P as the fitting needed for the high pressure hose ? ( Tuff Stuff 5550P: Power Steering Pressure Hose Fitting -6AN x M16-1.5...

Have a whipple 2.3 build i am in the middle of, but wont be going crazy with it. Will be more than likely never above 800hp to the wheels. Looking at the RXT twin disc and the spec 3 with a 26 spline also being put in same time. Really wanting something not too much of a leg work out. Was...

I know long shot, but looking for the carbon wing, radio and shifter bezels, door pulls, handle latch, and fog light bezels for the cobra. Payment ready shipping to 87144

Getting a 2.9 Whipple with accufab throttle body and SCT BA-3000, what's the go to intake? Was looking at the JLT next gen Ram air with the heat shield since looked a little cleaner in the bay