What kind of dyno numbers are you guys seeing with unported Eaton, stock 03/04 cams, 12# boost? (Dynojet numbers) Want to see if I'm in the ballpark or leaving power on the table. Thanks.
My Eaton is making noises, sounds like valve train noise. I pulled the blower and took it apart. I'm pretty sure the noise is the snout bearings. I spin it by hand and can hear it clunk/clang.
However, the rotors seem to be making contact too. When I move the snout back and forth I can hear...
I bought a low-mileage Eaton from ebay a few months ago and it has about 5000 miles on it (3K when I bought it). When I bought it the shaft turned with a little work - it didn't just spin freely but didn't feel like it was binding at all. Now it spins much easier but the unit makes what seems...
Motor is 4.6 32V forged bottom, 10.5:1 compression, 01 Cobra heads/cams, 03 Eaton, stock pulleys - 8lb boost, 90mm Lightning MAF, stock manifolds, 2 1/2" X pipe, no cats, burning E85.
I have a tune done by Sniper (Delta Force tuning) for me. I used their Special Forces software and built a...
I'm not sure if this is the right forum, but couldn't find a 'fuel system' forum.
I'm running 2 Walbro GSS340 HP 255LPH pumps, feeding a Y into a filter (near the tank). Then it runs 8AN to the rails and then to an Aeromotive A1000 regulator. From the regulator it runs 6AN (3/8 hardline) back...
A few spare parts for sale. All include shipping to lower 48 states, pay with paypal.
Ilder bracket for 03/04 Cobra, PN 2R3Z-8678-BA. SOLD
Vortech intake tube for 4.6, new SOLD
Bosch bypass valve for Vortech/Procharger (OEM), new $45 ($69 from Summit)
Power steering reservoir...
SOLD. Very nice 03/04 Mach 1 Intake Manifold. Actually, I think the lower intake is from an 01 Cobra (by the date code) and the upper is an 03 Mach 1. The upper was cleaned up on a wire wheel and is shiny, though not smoothly polished. Has upper to lower gasket, all bolts (upper to lower)...