Search results

anyone in dallas fort worth area know how to rebuild rearend. put irs on the mach while back and need it rebuilt. already have bearing kit and gears or a shop that wont charge me a million dollars to rebuild it.

going to remove ac compressor. was wondering if i could remove dryer and evaparator

anyone done cam swaps with heads still on block. just wondering if it can be done. any info would be greatly appreciated.

drivin mach round earlier and started racin ls1 and in second gear started cuttin out at bout 5grand and higher. just have diablo tune,intake and exhaust. air to fuel inbetween 13.8 and closer to 15.5 at higher rpms. any help would be greatley appreciated.

recentley put irs on the mach and just wondering which bushings need to be replaced first. off 01 cobra. just wnt to take it slow dont have the 500 or 600 dollars to do it all at once. thanks for the help.

have 2004 mach1 and put irs in it. car drives fine straight til bout 80 and gets real bad vibration and when u turn the car at low speed has a really bad clanking noise and when u push the clutch in it feels like driveshaft is still spinning when wheels stop..very hard to explain. it`is out of...

anybody want to trade. 2004 mach1 peeled sticker off so it is plain white. looking to do local trade so we dont kill each other in shipping. if anbody interested let me know.word.

just wanting opinions if worth the money. And what would be safest shot on basicly stock mach 1. just have intake and exhaust.

my mach1 is going to be sitting for the next 5 to 7 months was just wondering if i needed to do anything to protect it. we dont have much of a winter here in texas. car will be sitting outside.also am i causing any engine damage by letting it sit still. i start it once a week to keep the battery...

is there a how to section with details on a solid axle swap to irs. thanks.:burnout:

wanting to convert my mach1 to irs. my rearend is trash so if anybody has one let me know.thanks.

anyone in the fort worth texas area know of a good place to get rearend repaired. want to put new axles detroit locker and 3.73's back in it. then need to get trnny looked at for the syncro. wont go into second unless you shift real slow and when u do it grinds real bad. thanks guys

lookin to get a 01 cobra front bumper for the mach one. anybody no where i can get one? been looking at ebay and other sites but not havin any luck:shrug:

does anyone know where i can get the mach 1 stickers that go down the left and right side of the car. trying to put the car back together. thanks.

was wondering how difficult to install a supercharger off an 03 04 cobra and install on a mach 1. any advice would be helpfull