Search results

I have a 2000 Lightning with 2.6KB, 2800 sct maf in a 100mm tube 750cc RC injectors TF heads cams from MHS. The truck runs fine if I slowly get into it but if I get on it and go from 0 boost to say 6psi it will go lean to 14.5 to 15 afr for a second then go to 11.7afr I have sct prp software...

I currently have an issue with my tune. At start up it bank one will be at .876 and bank two will be at 1.245. after it sits there and sputters for about a min it cleares up and both banks are almost the same. What would cause this This is on a lightning with 2.6KB built satge 2.5 cam from MHS...

saling this 2400 edge racing converter theres about 3k miles on it got replace with a bigger converter so this is up for sale 360 shipped.

I have 3 homemade Metco drive shaft loops for sale. 40 +shipped +paypal

I have a heat exchanger for sale for a cobra. It has dual fans will sell for 250 with fans or 200 without fans plus shipping and paypal fee. SOLD

I am looking for a stage 2 jdm cam.

Today while crusing I heard a thump like it went out of gear. My overdrive light began to flash and I got all these codes 0135,0155,0443,0740,0743,0750,0755,0758,1229,1451, 1774,1754,1760

recently When i go to acelerate normally my truck kind of bogs down and shakes. I have a kb2.3 running 18lbs tr6 gaped at .32 dyanatech longtubes, jl sheetmetal intake. Before this started I got a bank one lean condition and it went away. Might it be a bad O2 sensor? I got it tuned at PSI so I...

Its a major problem cause I am in tx and its hot. My AC quit working I thaught it was low on freeon so i took it to a shop and they told me it had plenty. The compressor is working fine I checked all fuses they are good. Is there a relay for the ac and if there is where is it located? I applied...

Does anyone know the color code for our interior grey. I need to get a guage pod painted and wanted it to match.

Hey guys I pulled my plugs yesterday and I found one that was gone what I mean by that is the ground electrode was gone. A part of the ceramic peice was broken too. The tune is good I just got it redone at PSI so I know that is no tthe problem. Could it be that the injector is clogged and...

How can I tell what kind of lower I have I know its not stock. Is there a way to check?

I am looking at changing my stock cams to something better. So far I have a mmr900 block, KB2.3,JL Seetmetal plenum, dynomax longtubes, sct 90mm maf, running 16 psi, 2500 PI stall, magnaflow exhaust. When the mmr was put in the the valve springs were changed in anticipation to a new cam but it...