Search results

I know this is not the proper place to post this, but since they're only applicable to 94'-98' SN95s it seems apt. I found this listing on OfferUp for anyone looking for a set. Looks to be actual SVO skirts and decent condition too! No matching Borla exhaust though. 1994-1998 Mustang SVO side...

Just came across this video on youtube specific to 96 modular Cobras. Something not seen so often for our cars and thought that you guys might like to take a peek. Credit: Youtube U/N - daveshelbygt Credit: Youtube U/N - Mrchevy baja

This is a question for anyone who's running a turbo setup and live in an area where inspection/emissions testing is required. Outside of flat out bribing someone or "knowing a guy", how are you guys passing inspection and emissions with turbo setups on your cars? I'm considering a turbo setup...

Would anyone happen to know the specs on the exhaust manifold to midpipe studs? I'm trying to replace mine with stainless or new hardware and all my research has pointed to Dorman part number 03131, but these are used in the later years (too small). They use a 15mm nut, but the 96 setup uses a...

I've been doing some research lately and can't decide between LED/HID. DDM Tuning kits are approx 10% off right now, which is always a plus. But I don't know whether to go HID or LED. I'm trying to decide between...

I'll make this short and sweet. 96-98 Cobra (stock) Vortech V1 SC-Trim (3.6 pulley) Draw-through w/ Power Pipe (no IC/AF) Will the stock Cobra MAF peg?

As the title states, I'm looking to purchase Vortech oil feed/drain lines for a 1996 4V motor. Thanks

So two days ago, during morning traffic, I caught a faint burning smell. I thought it was just my imagination, but my air bag light immediately came on and it began flashing code 12. In the interior fuse box, fuse 4 was burned. I replaced it with another fuse and whenever I turn the ignition on...

So I'm looking to purchase a PI Headed/Intake Swapped SN95 GT for a daily driver. Car has 86k miles and is in immaculate condition. Only problem I noticed is after pulling the rear carpet off slightly to look at the condition of the trunk. I noticed this... Has anyone had similar rusting issues...

After pulling my trans to replace a severely worn throw-out bearing. (Six bearing were sitting neatly inside the clutch cable access cover). I've just decided to replace the clutch, pressure plate, flywheel, pilot bearing, etc. I've searched the forum and been sold on the Mcleod clutch. Can...

NVM ... Please delete this thread.

Here we go ... I've searched the forums for more info on this but could not really come to a conclusion. My 96 Cobra recently started acting up (rough idle) almost seems like it's running on 7 cylinders at idle speed. Actually, I gave a friend a ride to the local junkyard ... as soon as her...

So I got bored over the weekend and finally decided to install my lowering springs. I still need to install my CC Plates though and I know she's a dirty too. Let me know what you guys think. Pre-Installation (stock 4x4 stance): Post-Installation:

Just some quick questions which I've yet to find the answer to: (before anyone makes the comment, I've made great strides in using the forum's search function with no detailed or useful findings) I've recently purchase a 96' Mystic and noticed that the driver's side axle/axle tube is bent...