stalling

Here's the background: I bought my 1998 cobra #23 in laser red a year and a half ago. She had a spun rod bearing on cylinder 7, and the previous owner had the crankshaft turned .40 under. So, a year later. The motor rebuild is done, and it wants to idle at 1500-1800 rpm when in neutral and she...

OK guys need some help and possible direction. Have a 1999 cobra and out of the blue about three months ago its would just start dying when I would drive it. No rhyme or reason. Simply running great one minute next minute id would just die. Would turn over but not start. Replaced the...

Ok everyone....I need to know if this has happen to you cause I'm at my wits end. Suddenly about three months ago my 99 Cobra while driving or even at a stop light will suddenly stall and not restart. Sometimes it will restart for 10secs. and run extremely rough and then die again and not...

Hi All, When we pulled our 96 Cobra (all stock) out of storage this spring and drove to the gas station for fresh gas and air in the tires it stalled about one car length after bouncing through the approach into the gas station. It acted as it was flooded and only started after holding the...

Hello All! So I have never had a functioning coolant guage in my 1996 Cobra. Ever since I bought it about 2 years ago, its never worked. So about a week ago, I decided to change out the two coolant temp/guage sensors on the coolant crossover. The only one I was able to reach was the coolant temp...

Does anyone know how to test a MAF sensor? I have a stock MAF sensor that I believe is going bad, or it may even have already gone bad. I would like to test t prior to purchasing a new one. I have a 2011 GT500 that was running for months at an AFR of 11.8 at WOT and the AFR of 14.6 idle...

Hey hopefully someond can give my mechanic and I some advice on my 97 cobras stalling problem. I have a 97 cobra with 57,000 miles. I bought the car 2 weeks ago. It has 4.10 gears, high flow cats, h-pipe, new tranny and king cobra clutch. Last friday I started the car up with no problem. While...

I have a 03 Cobra I just bought. It has less than 24K on it and has been meticulously maintained and cared for. It has a 2.8 upper pulley,Amazon ported blower, throttle body and plenum. It was tuned by Amazon, dyno'ed at 483 rwhp/486 rwtq. The problem I've been having is very so often the...

I recently got a whipple 2.3, full exhaust, 60# injectors,single blade tb, and sct 2600Maf installed and tuned. The truck was running fine untill one night I was cruising. I floored it and kept it at full throttle till about 70 and the truck started choking. Anyone have any ideas on what could...