Well I finally got my cobra back from ford - they had it for 3 months. Got a new block, crank, piston, and everything in between because of a wrist pin failure.
Anyway I am getting it retuned yesterday, and my tuner is trying to figure out why it is so down on power on the dyno. Turns out that the gas pedal bracket is a flimsy piece of crap and was actually bent so that it was never getting full throttle. I can easily by hand, bend the bracket up a little to temporarily fix the problem, but I'm sure it will happen again. (had this same problem with my old firebird, and it was a royal pain in the ass)
So does anyone know of any after market manufactures of good steel or billet adjustable gas pedal brackets. I've been searching, and while there are tons of pedals out there, seems that they all use the factory bracket.
Anyway I am getting it retuned yesterday, and my tuner is trying to figure out why it is so down on power on the dyno. Turns out that the gas pedal bracket is a flimsy piece of crap and was actually bent so that it was never getting full throttle. I can easily by hand, bend the bracket up a little to temporarily fix the problem, but I'm sure it will happen again. (had this same problem with my old firebird, and it was a royal pain in the ass)
So does anyone know of any after market manufactures of good steel or billet adjustable gas pedal brackets. I've been searching, and while there are tons of pedals out there, seems that they all use the factory bracket.
