Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
SN95 Cobras
Any T45 guys here?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Serfma" data-source="post: 16869474" data-attributes="member: 196123"><p>Pulled my T45 due to at low RPM idle it would sound like it was knocking. Scared me because I thought it was rod knock but it went away once the clutch was pressed in. Input shaft had some more play side to side than I remember but it had a slight play in and out that I've heard is from the bearing + race. Pulled tailshaft housing off (for future forum dwellers, YES you need to pull the tailshaft housing off to get the input shaft out! Wiggle, twist, turn and you'll get it out.) and found 3-4 shift fork pad being broken on one end but the other fork looked fine.</p><p></p><p>Is there anything else I need to look for, or to replace while I'm in it? On a budget currently so I have the input shaft and counter shaft bearing + race to replace, but unsure if there's any other bearings I need to replace while I'm in it or anything else to inspect</p><p></p><p>Synchros have been good in the trans except for very rarely going into 3rd or 4th with a VERY quick shift would cause it to grind. I believe I have to pull the entire internals out to pull and press new bearing to the countershaft so I'll be able to inspect everything.</p></blockquote><p></p>
[QUOTE="Serfma, post: 16869474, member: 196123"] Pulled my T45 due to at low RPM idle it would sound like it was knocking. Scared me because I thought it was rod knock but it went away once the clutch was pressed in. Input shaft had some more play side to side than I remember but it had a slight play in and out that I've heard is from the bearing + race. Pulled tailshaft housing off (for future forum dwellers, YES you need to pull the tailshaft housing off to get the input shaft out! Wiggle, twist, turn and you'll get it out.) and found 3-4 shift fork pad being broken on one end but the other fork looked fine. Is there anything else I need to look for, or to replace while I'm in it? On a budget currently so I have the input shaft and counter shaft bearing + race to replace, but unsure if there's any other bearings I need to replace while I'm in it or anything else to inspect Synchros have been good in the trans except for very rarely going into 3rd or 4th with a VERY quick shift would cause it to grind. I believe I have to pull the entire internals out to pull and press new bearing to the countershaft so I'll be able to inspect everything. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
SN95 Cobras
Any T45 guys here?
Top