ATS Brembos on SN95 spindles - no spindle mod

[Mustang5L5]

These calipers do not fit with 95 cobra r 17 inch wheels
Hits the barrel of the wheel spokes clear great

Sent from my SM-N981U using Tapatalk

How did you mount the calipers? Did you drill out the spindle? Or use the inserts?


Sent from my iPhone using Tapatalk

 

[Cobragixxer9994]

Inserts

Sent from my SM-N981U using Tapatalk

 

[Cobragixxer9994]

It seems to me the caliper could be pulled into the hub more
I think I only need about 2 mm more

Sent from my SM-N981U using Tapatalk

 

[Mustang5L5]

The inserts do relocate the caliper downward. Did you install them in the correct orientation?

With mine, it easily cleared the barrel on every Oem 17” SN95 wheel I tried, just needed a spacer for the spoke. While I didn’t try a 95 R, it cleared a 98 cobra fine

Sent from my iPhone using Tapatalk

 

[Cobragixxer9994]

As far as I know I did the line up with the bolt holes perfectly

Sent from my SM-N981U using Tapatalk

 

[Nonotech]

I used the S&S engineering inserts kit with the spacer that it comes with and I have no problems at all, Im using the ATS Brembos and I have the 95 Cobra R installed right now and there is no problem at all, they fit and have plenty of clearance

 

[Cobragixxer9994]

It's seeming like I installed them wrong

Sent from my SM-N981U using Tapatalk

 

[Nonotech]

It's seeming like I installed them wrong

Sent from my SM-N981U using Tapatalk

Well the kit bushings are offset, they could've been installed incorrectly by mistake, double I would say double check it first to make sure everything is good to go!!

 

[Nonotech]

here is another pic, Im doing a build on the car, so Im not gonna be using those wheels, but are the ones currently on the car

 

[Cobragixxer9994]

I hope the inserts are repositionable

Sent from my SM-N981U using Tapatalk

 

[Cobragixxer9994]

Can you take a picture of your bushing orientation

Sent from my SM-N981U using Tapatalk

 

[Nonotech]

I don't have any picture of when I did it but I found these...

 

[Cobragixxer9994]

I followed those directions

Sent from my SM-N981U using Tapatalk

 

[Nonotech]

I followed those directions

Sent from my SM-N981U using Tapatalk

ohh, humm,
is the spacer inside the rotor against the hub or outside the rotor against the rotor face? do you have any pictures?

 

[Cobragixxer9994]

Behind rotor against hub

Sent from my SM-N981U using Tapatalk

 

[Nonotech]

Behind rotor against hub

Sent from my SM-N981U using Tapatalk

I don't know if you figured out the problem already, but one more thing that came to my mind is that the STS Brembos will also fit with the kit but are actually bigger on the top, they are almost the same.. other than that, I don't have any more ideas but hopefully you can figure out the problem!