Yup...the 99 cobra 44.5 shaft would work except for the bigger rear flange on the terminator.The shaft they made for you.
Seal to flange.
48 3/4.
Shaft should be in the area of 44 1/2 center to center.
I can see about 1 1/8 on rear flange. I'm guessing on the Trans yoke ,center of ujoint to where you want seal to ride ..
I remembered agonizing about getting a AL driveshaft the right length for mine.
Trans ?s, T-5, T-45, and 3650.
www.corral.net
Might be safer for OP to get another one made...or do the hybrid joint for short term.
Last edited: