Ford Mustang GT 2000 w/ 2007 3v Engine + More

Micah442

Blown 5.1L
Established Member
Joined
Dec 18, 2007
Messages
483
Location
Texas
2000 Ford Mustang GT
85k miles on odometer less than 5k miles on all new parts listed below
all work was done by PSI motorsports in webster,tx roughly 1 year ago

AfterMarket Modifications
2007 3v 4.6L Ford Mustang Engine
Stage II Comp NSR Cams
Stage II Ported Heads
Ram PowerGrip Clutch
Fidanza Racing Flywheel
Steeda Underdrive Pulleys
JLT Cold Air Intake
BBK Ceramic Coated LongTube Headers
BBK O/R H-Pipe
Magnapack Catback
3.73 FRPP Gears
03 SVT Wheels
Nitto Drag Radials

The Car makes 329 rear wheel power and 345 torque on current tune it is running on the 2000 computer and harness car would make closer to 360 rear wheel power on the new computer.
The windshield mister/sprayer does not work
The cruise control does not work due to the engine swap
The Drivers Seat is Faded Green from being in the sun.
The tint on the rear window needs to be replaced.
The hood needs to be painted the rest of the cars paint is fair for a 10 year old vehicle.

Serious Buyers ONLY 979-997-2941 - Brandon
$7000 FIRM Clean Title in hand


side.jpg

frontmustang.jpg

Engine.jpg

seat.jpg

backseat.jpg
 
Last edited:

Micah442

Blown 5.1L
Established Member
Joined
Dec 18, 2007
Messages
483
Location
Texas
What trans are you running? Any receipts for the engine work?

Using the stock T45. Here are a couple reciepts that I had for the engine and R&R work at PSI. Headers, Midpipe, clutch, hood and other accessories I not sure where they are placed. No Trades sorry...


PSI Receipt
PSIreciept_0002.jpg



BrenSpeed Where motor was purchased (Sorry its hard to read- $2800.00 for pullout 3v engine with 2k miles)
Brenspeed.jpg
 
Last edited:

Micah442

Blown 5.1L
Established Member
Joined
Dec 18, 2007
Messages
483
Location
Texas
shouldnt a stage 2 H/C 3v make more than 360? with your mods i was expecting near 400


Yes it'll make easy 360 really closer to 375-385 and up to 400HP. The PCM is limiting the car and not having the variable cam timing with the newer PCM.
 

Users who are viewing this thread



Top