Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
The Terminator
Engine/Tuning
Heat exchanger
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Blkkbgt" data-source="post: 16706642" data-attributes="member: 117234"><p>If you're serious about maintaining flow everyone should stop using those plastic short radius heater hose 90 fittings. </p><p></p><p>That short radius or turn will hurt flow. One may not be to bad but you keep adding them to your system and there could be a significant change in flow rate. </p><p></p><p>The other problem with them is the I.D. is smaller which creates another restriction in flow. They also tend to lack a chamfer on each end. </p><p></p><p>You would do better using a 1 inch hose barb to barb connector then add a long radius 90 degree elbow. There are different options out there that would allow you to accomplish this.</p></blockquote><p></p>
[QUOTE="Blkkbgt, post: 16706642, member: 117234"] If you're serious about maintaining flow everyone should stop using those plastic short radius heater hose 90 fittings. That short radius or turn will hurt flow. One may not be to bad but you keep adding them to your system and there could be a significant change in flow rate. The other problem with them is the I.D. is smaller which creates another restriction in flow. They also tend to lack a chamfer on each end. You would do better using a 1 inch hose barb to barb connector then add a long radius 90 degree elbow. There are different options out there that would allow you to accomplish this. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
The Terminator
Engine/Tuning
Heat exchanger
Top