Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
SVTPerformance's Chain of Restaurants
Tuning À la carte
Limp mode after trans pan swap
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mac 108" data-source="post: 15736875" data-attributes="member: 73734"><p>2009 P71 Crown Victoria with 2v 4.6 and 4R75E</p><p></p><p>Car was running fine with no problems initially until I swapped transmission pans.</p><p></p><p>I removed the stock pan, replaced the filter with a new Motorcraft piece and then installed an aluminum deep sump pan and refilled with Mercon LV. I double checked the old filter to make sure that the old o-ring was removed along with the filter.</p><p></p><p>After doing the trans work, the car went into limp mode. It shows the Wrench light and Check Engine Light. It barely idles if it runs at all and dies if you put it into gear.</p><p></p><p>It is showing the following codes:</p><p>P0135 HO2S Heater Circuit Conditions </p><p>P0155 HO2S Heater Circuit Conditions </p><p>P0403 Exhaust Gas Recirculation "A" Control Circuit</p><p>P0443 EVAP Canister Purge Solenoid or VMV Circuit Conditions</p><p>P0743 TCC Circuit Conditions</p><p>P0766 Shift Solenoid "D" Performance/Stuck Off</p><p>P0962 Pressure Control Solenoid "A" Control Circuit Low</p><p></p><p></p><p>What could I have possibly done wrong to cause this? It's the most bizarre auto problem I have ever had and I have no idea what I did to screw this up.</p></blockquote><p></p>
[QUOTE="Mac 108, post: 15736875, member: 73734"] 2009 P71 Crown Victoria with 2v 4.6 and 4R75E Car was running fine with no problems initially until I swapped transmission pans. I removed the stock pan, replaced the filter with a new Motorcraft piece and then installed an aluminum deep sump pan and refilled with Mercon LV. I double checked the old filter to make sure that the old o-ring was removed along with the filter. After doing the trans work, the car went into limp mode. It shows the Wrench light and Check Engine Light. It barely idles if it runs at all and dies if you put it into gear. It is showing the following codes: P0135 HO2S Heater Circuit Conditions P0155 HO2S Heater Circuit Conditions P0403 Exhaust Gas Recirculation "A" Control Circuit P0443 EVAP Canister Purge Solenoid or VMV Circuit Conditions P0743 TCC Circuit Conditions P0766 Shift Solenoid "D" Performance/Stuck Off P0962 Pressure Control Solenoid "A" Control Circuit Low What could I have possibly done wrong to cause this? It's the most bizarre auto problem I have ever had and I have no idea what I did to screw this up. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
SVTPerformance's Chain of Restaurants
Tuning À la carte
Limp mode after trans pan swap
Top