Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
The Terminator
Driveline
Locking out of 2nd gear when downshifting (t56)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="uhhhaaron" data-source="post: 16371518" data-attributes="member: 192759"><p>Recently picked up my car from a very reliable shop in Phoenix area. TOB finally went out and had all the components swapped out along with a 26 spline input shaft/McLeod clutch/lightened steel Fw, etc.. put in.</p><p></p><p>Drove from the shop not even a mile when a car pulls out in front of me while in 3rd so I try to downshift into 2nd and I’m locked out until almost to a complete stop.. hmm I drive a little further and experience the same thing. Drive back to the shop and owner takes it for a ride a verifies the same thing. Owner said to leave it overnight and he’d look it over. He’s pretty sure the front input shaft synchro wasn’t installed correctly..</p><p></p><p>this morning he notifies me had personally checked it and the front input shaft synchro was indeed install correctly.. he’s going to check this afternoon with his tranny guy and see what they discover..</p><p></p><p>Any ideas of what could be causing these lockouts? It shifts smooth while going through the gears 1,2,3, etc.. just downshifting I’m getting locked out until almost at a dead stop. Before this, my car shifted/downshifted fine..</p></blockquote><p></p>
[QUOTE="uhhhaaron, post: 16371518, member: 192759"] Recently picked up my car from a very reliable shop in Phoenix area. TOB finally went out and had all the components swapped out along with a 26 spline input shaft/McLeod clutch/lightened steel Fw, etc.. put in. Drove from the shop not even a mile when a car pulls out in front of me while in 3rd so I try to downshift into 2nd and I’m locked out until almost to a complete stop.. hmm I drive a little further and experience the same thing. Drive back to the shop and owner takes it for a ride a verifies the same thing. Owner said to leave it overnight and he’d look it over. He’s pretty sure the front input shaft synchro wasn’t installed correctly.. this morning he notifies me had personally checked it and the front input shaft synchro was indeed install correctly.. he’s going to check this afternoon with his tranny guy and see what they discover.. Any ideas of what could be causing these lockouts? It shifts smooth while going through the gears 1,2,3, etc.. just downshifting I’m getting locked out until almost at a dead stop. Before this, my car shifted/downshifted fine.. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
The Terminator
Driveline
Locking out of 2nd gear when downshifting (t56)
Top