Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Mustang Forums
SN-95 and New Edge Mustangs
Poor Build Quality Causes Interior Leaks?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="2003RedfireVert" data-source="post: 16954407" data-attributes="member: 203044"><p>I drilled two small holes on either wheel well inside the trunk. I got some small clear hose (1/4 or 3/16 or something), I got some small brass fittings with a hose barb on one end (male and female ends to screw then together). I punctured small holes on both corners of the boot, used the female end inside the boot, screwed it into the male end (that had the hose barb on it) on the trunk side of the boot. Hooked up the hose to barb, cut it to length and had it go out of the hole I drilled in the wheel well so it drained out of the car.</p><p></p><p>Hard to explain. Here is an example of the male fitting I used…again, had a female end that I screwed together with it (the boot being between them so I could seal it).</p><p></p><p>No pics. I did this back in 2012 before I even had an iPhone ha</p></blockquote><p></p>
[QUOTE="2003RedfireVert, post: 16954407, member: 203044"] I drilled two small holes on either wheel well inside the trunk. I got some small clear hose (1/4 or 3/16 or something), I got some small brass fittings with a hose barb on one end (male and female ends to screw then together). I punctured small holes on both corners of the boot, used the female end inside the boot, screwed it into the male end (that had the hose barb on it) on the trunk side of the boot. Hooked up the hose to barb, cut it to length and had it go out of the hole I drilled in the wheel well so it drained out of the car. Hard to explain. Here is an example of the male fitting I used…again, had a female end that I screwed together with it (the boot being between them so I could seal it). No pics. I did this back in 2012 before I even had an iPhone ha [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Mustang Forums
SN-95 and New Edge Mustangs
Poor Build Quality Causes Interior Leaks?
Top