Rear seat cushion clip release????

[Oh Three Cobra]

I'm trying to put my rear seat back in and can't figure out how to release the clips that hold down the front of the seat. When I took it out I just pried the seat up and was able to get an 8mm gear wrench on the bolts that hold the bracket down. I'm trying to get it back in now and need to release the brackets from the seat cushion so I can bolt it down first, then clip the seat down. Anyone know how to do this? Very frustrated here :bash:

 

[Emil]

Here's what the service manual says about releasing the seat:

Rear Seat

The rear seat cushion pad and frame (600A88) is retained in the following manner:

Pins are located on the bottom front of the rear seat cushion pad and frame which secure the rear seat cushion pad and frame to the front floor pan (11135).
The pins are inserted into locking plates on the floor crossmember with a push button release.
The bottom of the rear seatback frame is retained with screws to the front floor pan.

 

[Oh Three Cobra]

Thanks. Ended up figuring it out. Just had to push REALY HARD on the release tab.