Hey,
I am going to install methanol injection kit by AEM (http://www.aemelectronics.com/?q=pr...ion-kit-for-forced-induction-gasoline-engines).
I have some questions about the kit which will work with my VMP GEN2 TVS:
1. I have right now about 630-640rwhp and I was wondering which nozzle shall I use? (small, medium, large)
There is this chart: http://www.aemelectronics.com/files/pdf/AEM_Water_Methanol_Nozzle_Flow_Guide.pdf but i am not sure if i should follow it.
2. Where should I install the nozzle in my setup? Should be in the intake? If so where exactly?
3. Where do I install the PSI sensor which I got in the AEM kit?
Just to note: i'm going to use at first for the methanol only for lowering IAT and not going to change my current tune.
Thanks!!
I am going to install methanol injection kit by AEM (http://www.aemelectronics.com/?q=pr...ion-kit-for-forced-induction-gasoline-engines).
I have some questions about the kit which will work with my VMP GEN2 TVS:
1. I have right now about 630-640rwhp and I was wondering which nozzle shall I use? (small, medium, large)
There is this chart: http://www.aemelectronics.com/files/pdf/AEM_Water_Methanol_Nozzle_Flow_Guide.pdf but i am not sure if i should follow it.
2. Where should I install the nozzle in my setup? Should be in the intake? If so where exactly?
3. Where do I install the PSI sensor which I got in the AEM kit?
Just to note: i'm going to use at first for the methanol only for lowering IAT and not going to change my current tune.
Thanks!!
