Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
SN95 Cobras
VSS wire harness connector/speed calibration box install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="04DeadShort" data-source="post: 16717349" data-attributes="member: 70813"><p>I had bought the Dallas Pro Cal used years ago while planning to do a t56 swap. That plan got put on hold much longer than I expected. I was finally able to do the job a few months ago and when I dug the Dallas PC out of the box I realized I had no instructions. I was able to find a old write up on American Muscle that gave me enough info I needed to know where to put the wires. Basically I just used the the old O2 plugs I had, male and female to make my junction between the transmission connector, speed cal and car harness. I have a tool that allows me to take the pins out of the connector without damaging the connector or pin. I pulled the pins out of the original trans connector and plugged into the O2 style plug. Then I pinned the other plug as the instructions said for my speed signal to speed cal and signal out of the cal. I'll post the link below of what I referenced to. It's not the best but maybe it will help give you a idea or two.</p><p></p><p>[URL unfurl="true"]https://www.americanmuscle.com/speed-cal-install.html[/URL]</p></blockquote><p></p>
[QUOTE="04DeadShort, post: 16717349, member: 70813"] I had bought the Dallas Pro Cal used years ago while planning to do a t56 swap. That plan got put on hold much longer than I expected. I was finally able to do the job a few months ago and when I dug the Dallas PC out of the box I realized I had no instructions. I was able to find a old write up on American Muscle that gave me enough info I needed to know where to put the wires. Basically I just used the the old O2 plugs I had, male and female to make my junction between the transmission connector, speed cal and car harness. I have a tool that allows me to take the pins out of the connector without damaging the connector or pin. I pulled the pins out of the original trans connector and plugged into the O2 style plug. Then I pinned the other plug as the instructions said for my speed signal to speed cal and signal out of the cal. I'll post the link below of what I referenced to. It's not the best but maybe it will help give you a idea or two. [URL unfurl="true"]https://www.americanmuscle.com/speed-cal-install.html[/URL] [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
SN95 Cobras
VSS wire harness connector/speed calibration box install
Top