WTT: Built & Blown 700rwhp Mach1 for a 5.0

medrick

Member
Established Member
Joined
Jul 24, 2008
Messages
309
Location
Tulsa, Oklahoma
Looking to trade for a new 5.0 (convertible preferred). Car has 63,xxx miles a clean title (with a lien) and is located in the Tulsa area. These are just some random photos I have of some of the parts and the car. And with this much done to it I am probably forgetting some things. Car makes 563/540 to the wheels at 5500 with 10 degrees of timing on 91 octane and 705/627 at 6200 with 16 degrees of timing on E85 (could turn it up to 20 degrees and make 775 to the tires but what’s the point, 700rwhp is already a handful). Car runs great and has never been wrecked. Has a few rock chips on the hood. I have put about 5,000 miles on the motor since it has been put together. Car is very nice and clean and is built to a very high standard. No corners cut.

Mods:

Engine
3V WAP block .020 and all machine work done
Factory Forged Kellogg Crank
Stock Heads and Cams (valves lapped in before motor was put back together)
Oliver Billet Rods w/ ARP 2000 Rod Bolts
Diamond Pistons 5.2cc dish with valve notches (10.0:1)
Clevite Tri Metal Bearings
Total Seal Pro Select Steel Rings
ARP Mainstuds
ARP Sidebolts
ARP Headstuds
ARP Crankshaft Bolt
ARP Camshaft Bolts
Fel-Pro Headgaskets
Canton 7qt Oil Pan
Ford Hi Volume Oil Pump w/ billet gear
Innovators West 18% Overdrive Dampner
Thump Racing Tensioner
8 rib conversion w/ Ford Pullies
NGK TR6 Plugs

Transmission
03-04 Cobra T-56 w/ 60k miles (about 6k since opened up)
26 Spline Input Shaft
Viper 5th and 6th gear (.50 overdrive in 6th)
RAM HDX Clutch (rated at 650 rwtq)
Factory Flywheel (turned before put back in)
MGW Shifter w/ Silver Race Handle
Factory Cobra 6 Speed Shift Knob
UPR Firewall Adjuster and Clutch Quadrant (Factory Clutch Cable)

Rear End (0 Miles As It Is Still Being Put Together)
99-04 Housing Powdercoated with Welded Tubes
Auburn Pro Series Diff
Moser 31 Spline Axles
Moser 3” Studs
HPM Upper & Lower Megabite Jr Control Arms with Poly Bushings
3.55 Gears
New Bearings and Axles Seals
Drilled & Slotted Rotors

Exhaust
Stainless Works Longtubes w/ 3in Collectors
Stainless Works 3" X-Pipe (Hollowed Cats)
Spintech 3” Mufflers (currently no tail pipes because the IRS is still in the car for another week or 2)

Suspension
UPR Tubular K-Member & A-Arms
Maximum Motorsports Caster Camber Plates
Maximum Motorsports Full Length Subframe Connectors
Strange 10 Way Struts
Strange Front Coilover Kit with 250lb QA1 Springs
Strange 10 Way Rear Shocks (will be put on when SRA is installed)
Eibach Rear Drag Springs
UPR Bumpsteer Kit

Supercharger
Procharger D1SC Headunit and Piping
Treadstone 4.5" Core Intercooler
Black Boots
T-Bolt Clamps
3" Black Powdercoated Piping
Vortech Mini Race Bypass Valve

Intake
Factory Intake Manifold
3/8" Intake Spacer
SCT BA5000 Meter

Fuel System
Stock 04 Mach 1 Fuel Tank
2 Stryker 340 Fuel Pumps
-8 Pushloc Feed Line
-6 Pushloc Return Line
Seimens Deka 80lb Injectors
Fore Innovations Dual Pump Hat (New Design)
Fore Innovations Fuel Rails (New Design)
Fore Innovations Regulator

Electronics
Autometer Boost Gauge
Autometer Fuel Pressure Gauge
SCT X3

Cooling System
Factory Radiator
180 Degree Thermostat
Head Cooling Mod
Custom Coolant Crossover & Thermostat Housing Setup (moves thermostat to better location for more effective and accurate engine cooling)

Brakes
EBC Rotors and Pads
Stifflers Stainless Braided Lines

Wheels/Tires
AFS 18X9 & 18X10.5 03-04 Replicas
265/35/18 Nexen N3000
335/30/18 Toyo R888
3/8" Wheel Spacers All Around

Body Mods
03-04 Cobra Front Bumper & Sideskirts
Saleen 3 Piece Wing
Smoked Headlights & Foglights
HID Headlights & Foglights
LED Switchback Front Blinkers (Amber/White)
1" Shaker Spacer
Mach 1 Fuel Door
8" Antenna
5% Tint

Interior
Autometer Cluster Gauge Pod
All Lights Replaced w/ White LED's
MGW Cigarette Lighter
MGW E-brake Handle
Mach 1 Floor Mats
Brushed Aluminum Door Sill Plates

MISC.
Optima Billet Battery Tray and Cover (Engraved w/ "mach 1")
Optima Red Top Battery
SLP Line Loc
LED Backup Lights
LED Taglights
MRT Hood Struts
MGW Mach 1 Oil Cap
Clifford 10.5x Alarm System



machattarget.jpg


irsmach.jpg


intercooler.jpg


photo2.jpg


photo1.jpg


tubularfrontend.jpg


midpipe.jpg



machmotorbuild.jpg


dampnerandthumprrr.jpg


foreinnovations.jpg


forehat.jpg


kmember.jpg


ef378fe8.jpg


18d0abd9.jpg


7481cd32.jpg


front2.jpg
 
Last edited:

manolith

I Wanna go fast.
Established Member
Joined
May 6, 2011
Messages
2,856
Location
miami
dude i love your mach. i still owe around 10k on my car if i didnt we could had worked something out.
 

Users who are viewing this thread



Top