How to install MGW shifter on a t45 trans...

[Bullitt66]

for dummies.. lol. :banana:

So you just bought a mgw shifter, well, this is what you get.

So first, you take out the shfiter bezel, it is held by four clips, be sure you don't lose them..

then you take out the shifter handle

Then 4 bolts hold the rubber pad

then you can take out the 4 bolts holding the shifter, i bolted the shifter handle again to make it easier to remove the shifter base

then remove the gasket or silicone if you have some..

be sure you put the bushing that goes into the shifter in the mgw shifter

then put some silicone around the base

it should look like this

bolt the 4 bolts on the shifter

then adjust your shifter stops, put your shifter in 3rd or 4th gear, and adjust them, they should barely touch each other

then put the nut, so the bolt doesn't move..

if you bought the shifter inner dust boot, put it on now

then cut the stock rubber pad, so it fits the new mgw shifter

put the handle, and adjust it the way you like it..

This is how i put mine

then you can feel the difference..

i bought a composite race knob, just screw it instead of the stock knob, tighten it with a allen key and you're good to go