So will this mod help me from getting locked out of gears sometimes?
Man, I have a Steeda Tri Ax shifter, and I have absolutely hated it here lately because my car was shifting like shit. I just did this mod and whoa what a difference! I may not get rid of this car after all. Thanks for the info!
I actually cut abot 4-5 cm off didnt bend it and I can power shift no prob and gears now slide in without let the gas go.
now this pulls the slack out of the clutch cable ?
i just had my clutch replaced oem and its horrible compared to what it was. 1 gear is so tight, 2-6 i can live with, and then reverse is like a brick wall.
when my x pipe was installed yesterday, i took off that little trapped door on the tranny. im assuming this is the clutch cable ? there was soo much slack, i could unhook the cable
will this mod fix my problem or is it somewhere else ?
awesome, but did u just cut it or did u also adjust the clutch a few clicks??
:beer:Absolutely amazing.
The car is now a pleasure to drive.
No more missed shifts, grinding gears etc.
isnt this the same as putting the car in 1st gear when turned off and pulling up on the clutch cable until you hear a click?
No, it's not and that issue has been covered a couple times in this thread already. Please read the entire thread if you want to do the mod.isnt this the same as putting the car in 1st gear when turned off and pulling up on the clutch cable until you hear a click?
I cut it then push the quad up 2 clicks to take the slack out, cut n or bend n the plate is so when u let the clutch go it wont knock the adjuster back up.