Recent content by jackers

Let me know what you have. Looking to have some different sizes on hand for tuning.

Spring cleaning is here! I have the following: Flow Matched Racetronix 80# injectors: $325 Stock 2003 Cobra heads, 35K miles: $600 Performance Industries (PI) Stallion multi-disc 9.5" converter with 3500 RPM stall: 800

I have a set of flow matched (documentation will be provided) 80# injectors for sale. $350 shipped.

Long shot here, but I'm looking for the center pin that the oil filter attaches to. I see a bunch of coolers for sale, but I just need the center pin. Thanks

I can't believe I haven't participated in this sub forum before. There is some great info in here! I have a 2003 Cobra that just got a new engine build: 5.0 Boss Block Custom Diamond Pistons Total Seal AP Steel Rings Custom Cams Kenne Bell 2.8LC Non-E-85 Will see 15-17 lbs boost for a while...

I have a set of stock heads with about 35K miles. $600+shipping (no idea how to ship these beasts) PErformance Industries (PI) Stallion multi-disc converter, 9.5" - 3500 stall. $800 + shipping

I have a 9.5" PI Stallion multi-disc converter for sale out of my 4R70W. I've had the trans for about 5 years but blew my engine not long after having the auto put in (maybe 5,000 miles). This thing is like new. Stall is 3,500. I'm looking for $800 plus shipping.

I have a set of 03 Cobra heads that are just collecting dust. $600 OBO.

I have a brand new Kenne Bell 2.8 liquid cooled, mammoth supercharger I'd like to trade for a 2.9 whipple with crusher intake. Let me know if interested.

I have a 20V dual BAP(used) for sale. I can do $375 shipped, firm.

Just wanted to drop a quick line about the customer service at Metco. I talked to Rick today about ordering a couple replacement bolts for my interchangable lower pulley system. I somehow stripped the two long 5mm hex head bolts that hold the bracket to the block. Moral of the story, he is...

I am tearing my motor down today. Are there any specialty tools that I need for just the teardown, other than the harmonic balancer puller? My plan is to pull the heads while keeping them assembled. I have new Stage III heads that I'll take to my engine builder for when he assembles my...

I've seen a bunch of threads for Eatons and different models of KB's and Whipples but I haven't seen anything with the KB2.8 blowers with Mammoth intakes. Here is a link to KB's website showing the stock (7.5") and underdrive (6.55") crank pulley/upper pulley boost guide...

-Steggy late Stage IV port that Stage V was based off of it. It was designed for nitrous use but I never sprayed through it. I bought it used from 03Flamedcobra (Jon Thomas) who was hoping to get into the 9's with it and a shot of nitrous. Comes with ported TB and plenum. - &750+shipping. -Comp...

I have a slightly used set of 60# injectors with harnesses. These were installed by Horsepower by Hermann who flow matches all his injectors. $350 shipped. I also have the stock fuel rails. I don't even know how much they sell for, make an offer.