I have been sitting on a set of Twisted Wedge Aluminum Heads, that have been Ported with 0.041" Stainless Steel Wire w/56CC Chambers(milled) for a while and decided I should see about installing them. So naturally I have a few questions since I have never messed with Milled O-ringed TFW heads.
1.Can I run them with a stock short block?
2.What head gasket would I use? (I have seen conflicting info on them online running between I can run a normal head gasket because the wires are on the head to use a O-ring head gasket)
Thanks in advance!
1.Can I run them with a stock short block?
2.What head gasket would I use? (I have seen conflicting info on them online running between I can run a normal head gasket because the wires are on the head to use a O-ring head gasket)
Thanks in advance!
Last edited:
