BilletFlow Hub Installation

[whammy91]

if its in the wrong thread please move it mods.
didnt know where to put it so i just placed it here.

ok guys today at school i was installing the billetflow hub on the blower. \my teacher wanted me to find out if the hub backs out all the way to back of the snout were it hits all the way back. or if it just flushes in with the front of the snout were the screw goes on to and doesnt touch the back at all?.

and also is this the stock screw for it. it came with the blower when i got it but just wana make sure if you m112 guys have the same one?

 

[BBCOBRA]

The hub should be pressed on until it is flush with the front or end of the shaft. The bolt is just there to keep dirt and debris out of the snout shaft threads. Some (like mine) just have a plastic push pin pressed in there. The same type of push pin used to hold the spoiler on.

 

[TRBO VNM]

I think there are pics on BF's site of the install process. Check it out.

I have seen blowers come with a bolt and some with plastic push pin.

 

[whammy91]

i did check on there website. but it doesnt say anything about it being flushed at the front of the snout or if it touches all the way to the back of the snout.
if anybody has a hub installed on there car, can you do me a favor and just check it out please.

 

[futureSVT]

flush with the snout.

here is a how to with a good pic of the hub
Supercharger Pulley Install On 03-04 Cobra Mustang

 

[whammy91]

thanks for the info futureSVT. i got my question answerd.
now the only problem i have now is that i installed the hub backwords lol.
ill just take it off at school on monday and flip it around and install it again. thanks again

 

[Spoolx]

From their website
Supercharger Pulleys

Picture #6

This installed goes into the blower snout. Notice how the washers are set up before the pulley.
It is very important to get the pulley lined up correctly.
Make sure it is as perfectly parallel to the snout as you can get it.
These will hit the snout at the point where the pulley is flush with the snout.
As soon as you feel the resistance from the washer hitting the snout, you know that you have gone far enough.