MMR is pleased to release its Runner Control deletes / lockouts for all 2015 + Coyote 5.0 and GT350 manifolds. This kit locks the runner "flaps" in the full open position.
The benefit of the factory CMCV is to increase velocity through the port at low engine speeds. Supercharged and turbo charged engines however create their own velocity rendering the system ineffective and no longer needed.
This part is great for those using aftermarket ECU's or those just wanting to clean up the back of the manifold and make certain the runners are always fully open.
This kit is also great for those installing GT350 manifolds on 11-14 models that were not originally equipped with CMCV.
This simple bolt on take just a few minutes to install using the factory hardware.
Order here, just $39.99 http://www.modularmotorsportsracing...page=product_info&cPath=28_29&products_id=896
The benefit of the factory CMCV is to increase velocity through the port at low engine speeds. Supercharged and turbo charged engines however create their own velocity rendering the system ineffective and no longer needed.
This part is great for those using aftermarket ECU's or those just wanting to clean up the back of the manifold and make certain the runners are always fully open.
This kit is also great for those installing GT350 manifolds on 11-14 models that were not originally equipped with CMCV.
This simple bolt on take just a few minutes to install using the factory hardware.
Order here, just $39.99 http://www.modularmotorsportsracing...page=product_info&cPath=28_29&products_id=896