Up for sale or possible trade for pro street chevy/ mopar.
I bought this car from member tomcat almost 3 years agof and put about 1000- 1500 miles on it.
Sits covered in garage and used about once a month in summer as im either on my vrod or waverunner.
List of mods done before I bought the car as follows
whipple 2.3
sd 60# injector (steigmeier serviced & documented.
Leathal fuel kit (Dual gt 40 pumps ,pprv delete,modified fpdm.
jlt 9 inch carbon fiber intake w/ carbon shroud
sct3000 ma meter
even flow cooling mod
jlt oil seperators
billet flow idlers
kenne bell fprd
borla stingers
hr race spring
maximum motor sports irs subframe & diff bushings w/14 mm bolts
billet flow irs brace
spec 3 clutch
spec billet flywheel
liberty spline imput shaft
leathal retainer tube
ford racing hd throw out bearing.
Mods I had done list below
Weld in frame connectors
arh stainless 1.75 long tube headers and catless x
lfp dual pass heat exchanger
whipple single blade sc intake
lfp single blade throttle body
lfp 5 lb lower
lfp 2.25? upper. about 19lbs boost
Engine mods headers/sc intake I had had installed by shop next to performance dyno in NH
Tuned at performance dyno with torco tune 644/607. Has non torco tune in sct 3 if you don't want to run torco with a few less degrees timing .
Also new Wheel combo godspeed omega stealth black 18s with m/t 305 drag radials in back.
terminator rad shroud
lfp hood inserts
Tons of paper work, recipts
I am 3rd owner
car has egr and passes ct emissions without cats and valid emissions till 4/16?
I would give the car a true 9.5 and it runs strong and needs nothing but someone who will use it.
28.500 no low ballers please don't waste my time as I don't need to sell it.
Located in Nowralk CT.
I bought this car from member tomcat almost 3 years agof and put about 1000- 1500 miles on it.
Sits covered in garage and used about once a month in summer as im either on my vrod or waverunner.
List of mods done before I bought the car as follows
whipple 2.3
sd 60# injector (steigmeier serviced & documented.
Leathal fuel kit (Dual gt 40 pumps ,pprv delete,modified fpdm.
jlt 9 inch carbon fiber intake w/ carbon shroud
sct3000 ma meter
even flow cooling mod
jlt oil seperators
billet flow idlers
kenne bell fprd
borla stingers
hr race spring
maximum motor sports irs subframe & diff bushings w/14 mm bolts
billet flow irs brace
spec 3 clutch
spec billet flywheel
liberty spline imput shaft
leathal retainer tube
ford racing hd throw out bearing.
Mods I had done list below
Weld in frame connectors
arh stainless 1.75 long tube headers and catless x
lfp dual pass heat exchanger
whipple single blade sc intake
lfp single blade throttle body
lfp 5 lb lower
lfp 2.25? upper. about 19lbs boost
Engine mods headers/sc intake I had had installed by shop next to performance dyno in NH
Tuned at performance dyno with torco tune 644/607. Has non torco tune in sct 3 if you don't want to run torco with a few less degrees timing .
Also new Wheel combo godspeed omega stealth black 18s with m/t 305 drag radials in back.
terminator rad shroud
lfp hood inserts
Tons of paper work, recipts
I am 3rd owner
car has egr and passes ct emissions without cats and valid emissions till 4/16?
I would give the car a true 9.5 and it runs strong and needs nothing but someone who will use it.
28.500 no low ballers please don't waste my time as I don't need to sell it.
Located in Nowralk CT.