Got a killer deal on a short block

[phantom_5_liter]

From holcomb motorsports
wiesco pistons and manly rods with arp2000 bolts
my goal is 900
cutrently my set up is Roush Tvs 79mm pulley and intake with id1000 and auto swapped to 6r80
can my goal be reached?

 

[phantom_5_liter]

Huge shout out to Blazer707@TBR for the advice and way to go man

 

[92fiveohfox]

going to need a 69mm or lower pulley, ati overdrive and a small shot for 900. How much did the short block cost?

 

[Blazer707@TBR]

Glad everything went smooth man, Blake is as good as they come.

900 through the auto might take a little bit, just like mentioned maybe a 69mm and OD 20% balancer /E85 could be close. You will need a fuel system for the E85 at that power level also.

 

[phantom_5_liter]

4100
wouldnt the 69mm be overkill for my blower and block??

 

[92fiveohfox]

4100
wouldnt the 69mm be overkill for my blower and block??

Not if you want 900rwhp. VMP is running the 62mm and the ATI OD on their boss and only made high 800s I think.

 

[D98GT]

I run a build from Blake as well Probably one of the first coyotes actually with the girdle system. You did opt for that or sleeves correct?

 

[phantom_5_liter]

what is the griddle system? i got the cast iron sleeves instead

 

[D98GT]

You'll be fine with the sleeves; congrats on the big purchase man, I know how exciting it is

 

[FIFTY]

4100 for a sleeved short block ain't bad at all!

 

[Scott8583]

IT would take a lot to get a TVS up to 900whp. Head porting, cams, more boost, etc.

 

[Dizzyscure1]

4100 for a sleeved short block ain't bad at all!

I doubt that's real sleeves,

 

[wakebum2507]

did you get "sleeves"....or did you get SLEEVES?

 

[KPatrone]

congrats OP, I am finalizing my purchase from Blake on Friday.

 

[Blazer707@TBR]

I doubt that's real sleeves,

did you get "sleeves"....or did you get SLEEVES?

They are LA sleeves. I talked to a couple well known engine builders and they had nothing negative to say about them compared to the darton sleeves.

 

[Turd Fergusen]

Was the $4100 using your existing block or a new one? Did you send him your existing block for a core charge?

 

[KPatrone]

They are LA sleeves. I talked to a couple well known engine builders and they had nothing negative to say about them compared to the darton sleeves.

Same ones I have coming in my build

 

[96lasersvt]

Can anyone that got a sleeve setup from blake post pics of how thick they are?
Thanks.

 

[Dizzyscure1]

My friends motor has the sleeves that DON'T connect with each other if that helps any kinda like the old MMR sleeves.

 

[stretchb]

what I would like to know also ?