Ive got the car ripped apart right now. I'm replacing all the IRS bushings with the Full MM kit, using coupe springs that I will cut, installing MM FLSFC, etc. I bought the BF IRS brace when I bought the pullies last fall, but haven't installed it yet.
When I ordered everything else, I ordered a LPW IRS diff cover too, thinking I could use the brace with the cover for an even stronger setup. Well the brace won't fit the LPW cover, without lots of cutting and welding. What would be the stronger setup to run?
I was hoping the LPW diff cover was o-ringed like the Fore cover, but it is not. I just don't want this thing to leak when I put it together. Does anyone make a rubber diff gasket? I know you can use RTV, but one RTV sets, and if the car flexes at launch, it basically tears the RTV.
Thanks
Steve
When I ordered everything else, I ordered a LPW IRS diff cover too, thinking I could use the brace with the cover for an even stronger setup. Well the brace won't fit the LPW cover, without lots of cutting and welding. What would be the stronger setup to run?
I was hoping the LPW diff cover was o-ringed like the Fore cover, but it is not. I just don't want this thing to leak when I put it together. Does anyone make a rubber diff gasket? I know you can use RTV, but one RTV sets, and if the car flexes at launch, it basically tears the RTV.
Thanks
Steve