KB BAP question

[1stockgt]

I just installed my BAP over the weekend, and I'm not sure it's working. Is there any way on the car to tell if the BAP is operating properly. I'm waiting to get the ported blower installed before I take it to the dyno and have it tuned. I installed it according to Lethal's website and used their wiring upgrade kit. I set it at 25%, but at wot my w/b gauge still reads 12. Any help would be greatly appreciated. Thanks in advance....Rob

 

[sb03cobra]

You will not see it on your wide band.

You can datalog fuel pump duty cycle or just use a volt meter and check the output at the FPDM. With the BAP @ 0 it should read around 13v, turn the BAP up to 50% and it should read 17v.

 

[1stockgt]

Ah ok. Thanks for the info. I just wasn't sure if it was working.