CPRsm
Active Member
You think that stock mod engine is going to run 9's with 8 psi ?
You think that stock mod engine is going to run 9's with 8 psi ?
Nope.
Do I think with a few select mods, and some tweaking....that it could get close? Yup.
IF (yes, IF) lol......I can build boost from the line, then I think it would go much faster. I also have 17's on the front, instead of skinnies like I generally run. I ALSO added weight to the car with the auto, and different seats.
My guess, assuming everything is mechanically sound....is a [email protected] Dec 10. I probably wont cut better than a 1.8 sixty foot with no boost and a 3.73 gear....but we will see! With boost, the sixty would likely be in the 1.4-1.5 range like it was N/A and T45.
I won't be happy until it goes 10.49 on 8 PSI, as it sits. I will have to work on some things, including the tune...imo.
This thread is also making me debate an on3 setup for my 04 mach lol. How longs the kit been on modular ? I daily my mach1 so i cant be blowing it up! I mean they say on their site that a stock 4V will make XXX amount of power, but how long will it last is the question. I have a warranty on my car, but i'd hate to have to take everything off so an inspector doesnt fail it lol.
If your car is under warranty and you remove everything including the tune, most techs can determine that the engine was modified, down to the tune as well as inspectors. Most modulars can safely handle 8lbs on a conservative tune. The on 3 kit could probably use better waste gates from a good brand such as Tial, Turbosmart, etc.
I work at a Ford dealer, so it's not too hard for me... I guess its 1 perk of working here lol