i have a 2014 5.0 with a 8Rib paxton setup on a built motor and a stock 6R80 transmission. i daily my car everyday and wanted to know what pulley size should i go with the 3.12 or the 2.95 and im on e85 too. and what power are both good for
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
what paxton pulley size
- Thread starter Blackout5.0
- Start date
- Status
- Not open for further replies.
If it is a 2200SL I would just go with an ATI 20% OD balancer and 3.47 pulley to start with. A 100inch belt will work with that setup also.
If it is a 2200SL I would just go with an ATI 20% OD balancer and 3.47 pulley to start with. A 100inch belt will work with that setup also.
Isn't that roughly= to a 3.3 pulley? I know jpc said the 20% ati gives about 15% more boost so 3.48= 14 psi + 15%(2.1 psi) would be around 16. On the vortech site it says each pulley size is good for 1-2 psi.
Last edited:
Isn't that roughly= to a 3.3 pulley? I know jpc said the 20% ati gives about 15% more boost so 3.48= 14 psi + 15%(2.1 psi) would be around 16. On the vortech site it says each pulley size is good for 1-2 psi.
on a stock crank balancer 3.48 is good for 14psi
then a 3.13 will be good for 16psi
and a 2.95 18psi
seeing what pulley should i get for my setup
- Status
- Not open for further replies.
Users who are viewing this thread
Total: 2 (members: 0, guests: 2)
