I noticed in my datalogs that my "Load" is not pegged at 2 and my "Throttle Position Absolute" is not pegged at 950 so it got me wondering if my TB blade is fully opening. I checked it out last night and found that with the gas pedal fully depressed the blade is only open about 80%. I never had this issue with my old Accufab on my ported Eaton. I also noticed the cam on the VMP TB is way different than my old Accufab. The Accufab cam was very linear (nice smooth arc) whereas the VMP is sort of exponential......it has a small curve then basically a straight line.
Anyway, has anyone had to do any adjusting to get their VMP TB to fully open? If so what did you do? I would like to add that I already have the carpet trimmed under the gas pedal, so that is not an issue.
Here is the blade with the gas pedal to the floor...
Here is with the blade fully opened...
Here is the TB cam...
--Joe
Anyway, has anyone had to do any adjusting to get their VMP TB to fully open? If so what did you do? I would like to add that I already have the carpet trimmed under the gas pedal, so that is not an issue.
Here is the blade with the gas pedal to the floor...
Here is with the blade fully opened...
Here is the TB cam...
--Joe