Just curious if anyone else has ran into this issue. I have a 14 that I recently got the tune dialed in remotely with Lund. 3.6 KB and full bolt ons. I installed a mechanical boost gauge and went out to do a couple pulls to make sure it was reading right. After I was done and went back into town I noticed the car was missing pretty badly. I got it home and let it idle and you could hear the missing but there was no check engine light but when I checked codes in the ngauge I got P0300.
Just curious where to start looking. Was going to pull plugs and start there, I put TR7s in last spring gapped at .028. I do notice my AFR2s are jumping all over the place where my AFR1s are looking normal.
Also not sure if it's worth noting but I saw the drain for the cowl drains in the middle of the fire wall and was dripping down my exhaust because i could hear it sizzling and I was able to see where it was coming from. Didn't know if maybe an o2 got wet or something. Anyways, any suggestions are appreciated.
Sent from my SM-N960U using Tapatalk
Just curious where to start looking. Was going to pull plugs and start there, I put TR7s in last spring gapped at .028. I do notice my AFR2s are jumping all over the place where my AFR1s are looking normal.
Also not sure if it's worth noting but I saw the drain for the cowl drains in the middle of the fire wall and was dripping down my exhaust because i could hear it sizzling and I was able to see where it was coming from. Didn't know if maybe an o2 got wet or something. Anyways, any suggestions are appreciated.
Sent from my SM-N960U using Tapatalk