Almarktool's latest activity

Does anyone have an extra lying around they would sell ? 2R3Z-8A593-AB Coolant Recovery/Engine Coolant Recovery Tank Hose Thanks Mark

Im gonna try a block with hole in it and a 8mm bolt If not. I need to find directions on taking snought off and pressing it on i guess

No everything looks ok i got anti seize, so the set screw that goes into the big screw for pressing on keeps stripping out the threads...

So I got the factory pulley off no problem, got the new metco hub on partial way, still 1/2" or so to go, Metco tool keeps stripping...

Does anyone have a picture of the Metco Pulley Hub on their Eaton, I want to see how far on the shaft it is to make sure I press mine...

What is everyone using for this hose which does not seem to be availble ? Is everyone just buying the silicone hose kits ?? Thanks Mark

Thanks Bob, I got a good used set of single bearing ones for now, Do u think I should get bigger pulley than the 2.7 ??

Thank you everyone for answering, Just wanted to confirm the accufab wont do anything ? Money is not the issue. Just keeping it...

Hello all, and thank you to those who have helped in past with fuel tank questions, So I would like to do some simple mods to the 2004...

Thanks to all, tank came loose the next day I assume the isolation bonding tape finally loosened up

ok thanks will try, i think it must be isolations strips or something, some videos say u don't have to remove neck from fill door, i...

Hello there, Need some help, am I missing something ? I remove fuel filter line 2 lines on left 2 lines on right plug at rear of car...

Didnu sell the 2.76 pulley ?

Did u sell ?

200 I will foot the shipping