Recent content by Cobra_Meth

I've had my terminator back up and running with the new setup for the summer and when I was cleaning under the hood I noticed I forgot to put a ground back on, does anyone have an idea of what ground this one is so I can hunt it down. Thanks Uploaded with ImageShack.us

Had my car on the dyno a few weeks ago and I picked up a Fast dual wideband setup and found that drivers bank runs @ 9.6:1 wot and passengers side runs 11.5:1 wot. Anyone have any ideas? What should I data log to find the issue, or is it just my tune all together. Any help would be appreciated

Just to revive a little faith back in Crower I had my new setup on the dyno for a baseline tune @ 16.5 psi with long tubes and diamon -11cc pistons @ 19 degrees of timing and a very conservative A/F. What do you guys think? And I did buy these cams from a good member from Florida on this board...

Hey guys, I got my aluminator all fixed up finally and installed a set of crower stage 4 cams springs/retainers with cloyes adjustable gears. The cams degreed out at 110/114 as the cam card specs. I went to fire up the car and it will not run. The person I purchased the cams from said that...

Hey, After my aluminator died and FRPP did not really come to the table I have went the route I should have went and compiled some parts and do a build myself. I am looking for suggestions to see if I have any missing links. I will be starting assembly with my engine builder this weekend...

Hey everyone. It seems that we are all curious as to the pistons the aluminator comes with. I pulled mine apart tonight. She had 1,500 km on the install. The car was tuned at STEEDA.CA. I have attached a few pictures to try and get some advice on what might have caused this. This is my 2nd...

I installed a new aluminator with a whiplle 2.3 in sept i went to the dragstrip mid sept the car worked great, dyno tuned at just over 600 etc etc etc, i was out in October and the car died mid track and oil was spewing out of the valve cover breather. Did a compression check and #2 piston has...

I took my K&N cold air intake off today and noticed a build up of oil around the throttle blades. Has anyone every experienced this. I do filter my PCV system and have a filter element on the passenger side instead of the pcv running in the intake. Seems like trouble to me. Any help would...

Got a question here, has anyone had an issue with a KB BAS that it keeps blowing inline fuses? I think mine must have went defective. Any help would be appreicated.

Please email me at [email protected]. I am paypal ready! Thanks Randy 905-260-4996

Hey guys, I just found out about your site today. I picked up a used 04 Cobra with 40,000KM, a few mods but it has a slight miss in the motor at idle and around 2000 rpm. I did a compression test and its 155 across the board and the previous owner have NGK TR6's in there gapped at .35...