Recent content by CrazyBoost

Gen 3 blowers are 2.65

Still for sale?

Did this car ever sell?

2003 Ford Mustang Cobra Contact information: Name: Jeremy Email: [email protected] Text/phone: (804) Four Seven Five One Five Three Two Mileage: 85,000 Price: SOLD Video: https://youtu.be/VOOvP8LFPGc Motor: · Stiegemeier Ported Blower · Stiegemeier 2.93 Inch Upper Pulley ·...

Anyone know of a good place to have the rear end rebuilt near Richmond Va? I'm willing to go about 100 miles north or south of Richmond for quality work. I believe the crush sleeve has collapsed and I want to go ahead and replace all the bearings also. I will take the pumpkin out of my Cobra. I...

So my car used to idle between 750-800 rpm's which is right were I wanted it. One day it started to idle higher (1000 rpm) which made me think the iac had gone bad. I replaced it but now the idle won't go below 850-900. The strange part to me is if I turn on the ac/defrost it will go back down...

Does anyone make projector headlights for the stock bulbs that don't have the stupid halos? I have LED bulbs in my headlights and I want to add projectors to finish off the look. I know there was a guy retrofitting the stock headlights but I can't find him now. Anyone know of someone else?

So I'm putting on a new pulley setup and I want to get confirmation on the correct belt size. I'll have a 2.76 upper, 4# lower, 4 peice billetflow idler set, and a 3.20 alternator pulley. Using Cobra Bob's belt guide I think I need a 78" belt. Anyone know for sure?

I want to get the front fenders on my car rolled but I want to find out want to do about the inner fender liners since the fenders won't be able to hold them up anymore. What do you guys do?

Basically my upper pulley looks just like the Metco upper, black with four mounting bolts, but it has Stegeimer etched into the front. Did stegei ever make pulleys? Also can anyone tell me what size it is? I have the stock lower, stock pulleys, and motoblue idler with a 75" belt.

Ever since I bought my car years ago I have wondered if I have aftermarket gears. Maybe it's because I drove quite a few C5 Z06's before purchasing my Cobra but it seems like the rpm's stay high in sixth gear. At 70 mph in sixth gear the car is sitting at exactly 2k rpm. Is that stock?

I'm running a ported Eaton for at least another year but I'm putting on a 2.76 and maybe a 4 lb later. I already have a boost-a-pump. Will steigi up size injectors be enough for a tvs later on? Will 80 lb injector be to much/tunable now? Which injectors should I go with?

So about a month ago I did a third gear pull getting onto the highway and when I went to shift into fourth the peddle was extremely hard to push and it wouldn't go into gear. I ended up having to have it towed since it wouldn't go into any gear. I figured the trans had finally given up since it...

Is there any special technique to remove the transmission? I've got the wires and clutch cable disconnected along with the eight transmission to bell housing bolts out including the bitch bolt but it doesn't seem to want to come out. Is there any special way it needs to come out or am I just...

I bought my car used and it already had a centerforce dfx clutch in it. Is there a way to tell if the input shaft has been upgraded with it? I know there is a cover over the clutch fork area but looking at pictures it doesn't look like it will be far enough forward to see the splines. The...