killer chiller SOLD
Metco driveshaft safety loop. Brand new in box $60 shipped
I can email or text pics. For some reason I can't get my photos to upload
Email or text with questions.
[email protected]
417-438-3553
Got my car tuned a little over a month ago. Ran great at the shop, made 723hp on E85. Fast forward to today. Car idles like crap, goes from 1200 to 800. Back and fourth and sometimes it just dies, but will start right up again. Anyway, wide open in 2nd the car just completely cuts out at...
Well after 8 months of down time and a busy work schedule, I was finally able to get down to Dallas to get my car tuned. Manny at HPP did a great job again for me. Everyone at their shop was very nice and helped me out with a few little issues along the way. The 12 hour round trip was...
Just put on my 2.9, and lethals 1400hp return fuel system. The boost bypass and egr were deleted by the previous owner and I deleted the Frps. My question is where do I plug in the vacuum lines that went to the top and bottom of boost bypass? Also does the vacuum line from the Frps go directly...
Like the title says. I bought this when I was going to turbo my cobra. Ended up not doing it. I've only taken the sensor out of the box to take pictures of it. Ill take $175 shipped for it. Pm, email, or text me for quicker response and pictures 417-438-3553. Email [email protected]
Not sure on how many miles these parts have on them. I've owned the car a year and put about 1000 miles on it. The car has 36k on it. Dyno sheet says 495/495
Apten Ported eaton with 2.80 upper, with egr delete, comes with boost bypass.
Whipple 3.50 stock upper pulley off my 2.9. Never been...
Just took one out of my car and want to sell it on the market here. I just don't know how to tell if its a 20amp or 40 amp. I can't find any numbers on it except for 2 small sets of numbers stamped on the back plate. It says 30 and 17 on it. It has a 30 amp fuse on the power wire.
Not sure on how many miles these parts have on them. I've owned the car a year and put about 1000 miles on it. The car has 36k on it. Dyno sheet says 495/495
Whipple 3.50 stock upper pulley off my 2.9. Never been used. $50 plus shipping
Auxillery idler and bracket, not sure what brand...
Dropped the tank to do my return system. Trying to get it back together now. What is the easiest way to get the rubber grommet on the filler tube back on the tank? Should I take it off the tube and put it on the tank while its out from under the car or should I leave it on the tube and try to...
Installed the kit on my car yesterday. Everything was very easy. Almost to easy. I've read on here that its a tight fit getting the piece with the o-ring into the freeze plug hole. But mine just pretty much fell right in. Once i could tell it was seated all the way down I figured it would be...