Have a 2001 Ford Excursion Diesel and recently have had some issues with the power-steering.
I changed the power-steerng pump due to some pulley noise and now noticed that the steering tightens when the brakes are applied but is normal when running.
Has anybody encountered this or know about...
I used to get 220miles to a full tank of gas with a stock truck only with a CAI installed. I recently noticed that i am now only getting around 185miles with a tank of gas.
The only thing different i did in my last oil/plug change up was to gap my plugs in the .034-.036 range as opposed to the...
Can anybody point me to the right direction looking for the support/mechanism that holds the hard tonneau cover for the L open.
Looking for the locks as well found on each side of the tonneau.
I have the "original" hard tonneau that i sourced from the local ford dealer but they can't seem to...
Hi guys, need to decipher the reading i get on my boost gauge. On idle, it reads 20 under the zero. Is this normal? and when i accelerate, it only goes up to about 5-8 over zero.
Is this normal? did i install it wrong?
Thanks for your inputs in advance.
Pic shows gauge at idle.
Can anyone recommend a place in California (as close to OC as possible) where i can have a pint of Performance white mixed to retouch a scratched panel? I have tried dupont and other paint brands here in the Philippines and for some reason matching is very hard.
Thanks in advance for your help.
Will the pcv delete throw a CEL P0171, P0174? What i did was use Chiz's method on the driver side and just block of the hose with a cap on the passenger side. I did not remove the t-connector on the passenger side and i just blocked it off with a cap as well.
Any insights would be appreciated.
Can anyone tell me where the Baro sensor is located? and does anybody have a picture of it?
I read somewhere in SVTP (http://www.svtperformance.com/forums/2nd-generation-22/203104-barometric-pressure-sensor-ses-light.html )
that our MAF sensor is the BARO sensor. Is this correct?
Does this...
How do i know if my regulator settings are correct from the get-go?
I opened it up a little when i was getting a P0171 error.
How do i know if i have optimized settings?
Sudden change of wind and i have recently paid more attention to my L more than i have in all the years of ownership. Maybe because of its new lease on life since it went under water.
(See L under water here...
Can anybody tell me if it is possible to just purchase 2 pcs of wheel lugs/studs for the front hub of the lightning? I broke 1 upon tightening and the dealer says i have to purchase the whole hub for $100++. Maybe someone has an old hub lying around. Lug diameter is 12mm and length is around...
If anybody has any old wheel hub or wheel studs they want to sell, please send me a message. One of my wheel studs broke upon tightening and the dealers says you have to buy the whole hub.
If anybody has replaced their hubs or have any wheelnstuds lying around, i'd buy them, shipping to CA...
Would like to get your advice on what exhaust to put and what do i need?
I've seen a couple in the market place but don;t know if they will fit my 1999 Lightning. I want to change everything from the headers to the exhaust tips. what would you guys suggest? will those long headers work? what do...
Hi guys. hope you can help me. my lightning has the error code P0171 system too lean bank 1.it kkeps coming back not when the car is running but it shows once you start up the car.
History of my car is that it is a flooded unit and took ford 7 months to fix. i changed everything needed and...